How to save the phone when it gets wet in the water
Has your cell phone accidentally dropped into sync, or worse … in the toilet? Or, have you ever forgotten it in a pocket or washed it in a washing machine or could your friend push you into the swimming pool in fun? Have you ever been caught in the rain or have you gone to swim in your pocket? Or have you ever fallen into a water pot from your pocket? Draining your cellphone means that you have to change it, but if you take immediate measures, sometimes you can save the phone. By adopting the steps given in this article, you can save your fallen phone.
Get the phone out of the water as soon as possible:
Hands-free port, small aperture of the microphone, charging, USB cable plug, how many of the plastic cover of the phone, when the water is easily accessible in a few seconds goes. Take the phone off with it immediately, if you leave it, you can have a short circuit – if it is in water then assume that water will be rushed, and it will not be working right now.
Your phone will not be too bad if you take it out of the water quickly:
Staying dipped for a long time, like rotating in a washing machine, can be a danger bell. The following efforts can be important to protect it before giving it up.
If the phone is connected to the wall charging and goes into the water then do not try to remove it from the water. Call a professional immediately and ask about the right steps to take security (like shutting down the power switch or something like that). Water and electricity never get together; If there is a lightning shock, However, if your phone is not connected to the wall charger and falls into the water, then take the next step by removing the phone as much as possible from the water.
Accelerated steps can be effective in protecting your phone from the waste of water, whichever is not afraid. To remain consistent, the key is to work properly under pressure.
- After the phone is removed from the water, quickly combine the paper towels and soft clothes on which to put the phone on its battery lid and remove the battery: this is a very important step to save it.
Many of the inside circuit remain clean even after going to water if the power source (battery) is not put in the wet.
If you want to know if the phone is really damaged by water, look at the white corner round or square sticker near the battery.
- It can also have a red line or not.
If that line is pink or red then the phone is spoiled with water.
- If you do not know how to remove the battery, then quickly see your phone’s consumer booklet.
Remove the SIM card in your phone:
Some or all important contacts (and other data) also saved on your SIM card. Too many people save it is more precious than the phone.
SIM cards are kept away from the danger of water but it is wise to take it out early. Leave it for drying and drying, until it needs to be replaced again. (If you do not have a SIM card in your phone, skip this process.)
- Remove all the peripherals, such as ear buds, memory cards, even all shells and protective covers. Remove all the shells that have placed the pores of your phone, slots and circuit and dry in the air. leave for.
Dry the phone with soft towels or soft cloth:
As long as there is a single drop in the water, it can waste your phone and rust its circuit. So you should get as much water as possible as possible, to prevent the malfunction of the phone.
Wipe out the water as much as possible without slowing down the phone. Avoid excessive shaking and moving, so that the water does not move around.
Use towels or paper towels to wipe, try that the paper does not get caught in any crack or groove of the phone. Carefully kept water till the water left over.
If you have removed the battery in a while, then the water will dry after wiping alcohol in the phone.
Use the vacuum cleaner:
If you want to draw water from the inside of the phone, use the existing vacuum cleaner. To remove all the moisture inside, use the vacuum cleaner for up to 20 minutes on various parts where you can get access.
This is the fastest way to dry the phone completely and make it work within 30 minutes. Whatever it may be, even if the water is very little, it is advisable that you do not turn on the phone immediately.
Be careful; do not take the vacuum cleaner very close to the phone, because it creates static electricity from the vacuum, which is also dangerous for water for the phone.
Do not use a hair dryer to dry the phone:
Contrary to popular belief, it is not right that you use the hairdryer (also in “cold” mode). Using a hairdryer, moisture can reach the inside of the phone’s circuit and electrical appliances. And if the air dryer’s air is too hot, it can happen.
If the air is placed on the open space of the phone with a hot heater, fan or some similar device, it is possible to dry out in contrast to the air blowing in the phone. According to Barnaul’s theory, hot air flows over the phone faster, due to low pressure, moisture exits from the phone. The good thing is that you can leave the phone without working hours in front of the hot air.
Use the kind of things that cause moisture to emerge:
The unpaid measure that the phone should placed in raw rice utensils or bags overnight. Wrap grains like rice or phones in paper towels. Rice will absorb the remaining moisture.
Use absorber if possible. The absorbers absorb good moisture from the rice. You can also do that by putting the phone in the airbag and putting the absorber in it.
You can keep the absorbers such as silica gel, found in the shoes box, found in the noodle bag, with the absorber phone inside the purse. The downside is that the absorber found in the shoe packet will have lost its absorption capacity. Flowers drying absorbers can bought from many craft shops. Leave the phone as much as possible with absorber or rice (for at least nights).
Keep the phone moving around for hours every day. In this way, the leftover water will rolled out from open spaces.
Place the phone on towels, napkins or paper:
After removing the absorber or from the rice (or the method you used to use), keep the phone on the absorbing item. Remember that your objective is to take out all the moisture out of the device.
Keep an eye on the item that absorbed every four to six hours. If moisture is visible then repeat the process of vacuuming and the absorption.
Check your phone:
you wait for 24 hours, even more, if needed. See that the phone is clean from all the places and is looking drought. See all the ports, circuit, and in the rooms that do not have dust or moisture. Wipeout dust and dirt from the phone and its cover or battery. Try to turn on the device, there is no different kind of sound or symptom, check that the phone is working properly.
If your phone still does not work, put it in the battery charger without charging:
If this is working then you probably need a new battery.
Take your cell phone to an authorized dealer:
Sometimes they fix it. It does not hide the truth that it drenched – there also some indicators inside that show that there moisture in it – and the repairers will able to cooperate with you if you tell that what really happened with the phone.
If you are not aware of it, never open the phone in different parts:
Leave it for the professional person, because doing so can shock electricity or face dangerous chemicals.
If your phone not functioning properly after it turned on, while you dried up, it means that some water still hidden inside. Remove all covers, batteries, cards and extra items, and rinse with dry paintbrush or toothbrush. See this process on YouTube .
Buy a protective case for your phone: